Description

Bolts: Grade 5 steel coarse thread (or better)
Washer: Grade 5 steel Flat washer (or better)
Nut: Grade 5 steel nut (or better)

Are you planning on building your own sealcoating tank with agitation? This 1-1/2" kit is for you!

We've used this style of bearing for well over a decade on our BIGA sealcoating tanks and haven't had any problems with them outside of the normal wear-and-tear. Keep in mind, the OD of the shaft pipe or rod can not exceed 1.50" and we actually recommend using a shaft that is slightly smaller for easier fitment.

The F-2XX series flange bearings are designed to rotate within their housing which gives you some lee-way on positioning the shaft and bearings on each end. For obvious reasons, we recommend that they are installed as straight and level as possible, but in case you're a little off, these bearings will give you a small amount of forgiveness if things aren't perfect.

What you'll get with this bearing kit

2 x 1.50" F208 flange bearing
2 x 1.50" Rubber gasket
2 x 1.50" Mounting bracket

Note: Brand of manufacture may vary.

Optional Hardware

Hardware is not included however, you can add the bolts, washers, and nuts as an option before you add-to-cart.

If you choose to add the hardware, keep in mind it will accommodate tank thickness up-to 1/4" (3 gauge). If you are using additional brackets or have a thickness beyond 1/4", we recommend sourcing your own hardware to ensure proper fitment.