Does high durability, high build paint sound like something you would be interested in? The Swarco 1110 Series is a fast dry 100% cross-linking acrylic latex paint that meets or exceeds the TT-P-1952F Type III (Type 3) US Federal specification.
According to the federal spec, Type III is designed for increased durability. OK, but what does that mean?
For use under normal weather conditions where higher durability and greater adhesion to glass beads is desired. Minimum application temperature should be 12.8°C (55°F) and rising. Low temperature will result in greater dry time, especially when specifying increased thickness as required when using Type IV beads.
In other words, 1952F Type III paint is a very durable, high-build paint that is ideal for Type IV glass beads. (Type 4 glass beads aren't that common but if the job calls for them, then a high build paint like this one will be needed)
The Swarco 1110 Series is listed with many states as an APL / QPL, you can buy in confidence knowing this specific formula is allowed to go down on state** highways, roads, and streets. It is also approved as a Federal paint for airport runways where higher-spec paints aren't called for, or it can just as well be used on parking lots. Basically anywhere asphalt or portland cement is used, this product will work just fine.
** Always check with your states APL / QPL before purchase. If Swarco paints aren't approved for your state but Ennis-Flint is, feel free to contact us for pricing on a comparable Ennis-Flint substitute. +1(800) 689-2098
So who should use this paint? Since it is approved by many states, it's ideal for state workers or contract construction crews working for the state to be used on highways and roads. It's also great for cities, counties and even small contractors looking for quality paint who want to save buying in bulk. Really, it's a great all-around paint for anyone in the line-marking industry.
As far as surfaces go, you can use the 1110 series paints on highways, roads/streets, parking lots and airport taxiways or runways, especially where the 1952F Type III spec is explicitly called for.
Did we mention the "No Track" time of this paint is 90 seconds or less? Yeah, it's a super-fast drying paint. Keep that in mind if you're spreading glass beads by hand. The "no pickup time" (without glass beads) is 10 minutes or less and the full dry-through time is 2 hours or less @ 15mil thick, wet.
Another area you might be concerned with is the VOC limits which have become the primary force behind a lot of spec updates. The Federal spec requires the VOC limit to be less than or equal to 150 g/L. The 1110 series comes in at less than 100 g/L, so it's way under the federal limit for volatile organic compounds and designed to meet or exceed even a lot of the state-level specifications.
What you're getting with this purchase, is a full pallet of 5-gallon pails yielding 32 buckets for a total of 160 gallons of paint. This product is only available in full pallet quantities however upon special request, we can mix-and-match the colors within the pallet. The price may vary slightly on mix-and-match orders so feel free to call for a quote if you need a variety of colors +1(800) 689-2098
General Coverage
80 square feet per gallon at 20 mils wet film
240 linear feet per gallon, 4-inch line at 20 mils wet film thickness