QuikHold Squares for Reflectors or Asphalt Repairs

Do you need an easy-to-use asphalt surface repair patch or adhesive for road reflectors? The QuikHold Squares are not only easy to use, they hold up to abuse, giving you a professional product that is great for contractors and excellent for DIY enthusiasts.

The QuikHold Squares are an asphalt-based material that is sold in three different sizes to match your needs.

Choose the 4" x 4" square as a fantastic adhesive for road reflectors.

8" x 8" squares are great for small alligatored areas or you can use them as construction cone fasteners.

If you have larger alligatored asphalt and need a great product to seal up the cracks, use the even bigger 12" x 12" squares to do the job.

You can also use these patches for temporary or even permanent solutions for cart stalls, car stops and speed bumps!

Installation is super simple. Peel the paper wax from the bottom of the square, place the QuikHold Square where you want it to go, making sure the plastic film is facing up and press down into the pavement firmly. Finally, evenly heat the patch with a direct-fire propane torch, moving the flame around until the QuikHold Square has liquified. Allow the material to cool for 5 - 10 min and maybe sprinkle some sand over it before allowing traffic. Sand is up-to-you. Allow it to cool and cure a bit longer if you don't sprinkle sand on the patches.

If you're installing a reflector, heat the area until the area liquifies, then immediately push the reflector down into the patch material and allow it to cool. Give the patch 5 - 10 min to cool and you're ready for traffic. Reflectors won't need sand for obvious reasons.